Hi everyone! For today I've got another how-to that has been requested a lot! I'm not saying this is the way to do it, because I'm sure everyone has their own preferences, but this is my take on it! The end result in the last picture is really awful, please forgive me, but I was working (too) fast because it's still subtropical in The Netherlands and I almost succumbed to the heat!
Before you start anything, you want to make sure you got the right stuff right in front of you. This will minimize little problems like knocking over very expensive nail polish remover or nail polish and the likes. (At the end of making these pictures I had nail polish on my cheeks and an almost empty bottle of Zoya Remove +).
Stuff you'll need
|
|
1. Roughen it up!
This is a step that you really don't want to skip. Just grab a medium file and file lightly over the stamp. If you don't do this, it most likely won't pick up nail polish at all.
2. Polishes
Before you start prepare a cotton pad (or more) with nail polish remover and lay it next to the plate. You'll have to clean the stamp (and sometimes the plate) after every go. By using something like tweezers to pick up the cotton pad you won't mess up your manicure.
The polish you use can really influence the end result. Konad sells special polish for stamping, but if you got some really nice pigmented (one coaters and such) nail polishes, you can use these too!
You don't have to fill the entire design on the plate, just apply a bit at one side of the pattern. (I accidentally kinda went overboard while I was taking pictures so you can use less than pictured).
3. Scrape
Most Konad kits come with a scraper. I don't like it. It's sturdy and damages your image plates like no other. Using a plastic card is easier on the plate and it's easier to move around anyway.
Scrape your polish from one side to the other, making sure the nail polish fills every gap in the design. Don't press too hard, because you don't want to scoop nail polish out of the grooves.
4. Be like Speedy Gonzalez
Speed is a really huge thing when you're Konad-ing. You really have to work fast or the polish will turn too dry to pick up with the stamp.
5. Stamp
After you applied nail polish, scraped around, immediately place the stamp on the design. You don't have to press hard, it will only mess up the design.
6. Press
Now you're good to go. Depending on your nail shape, there are several ways to stamp on the nail. My nails are a wee bit curvaceous, so I don't place the stamp flat, from the center. If you have really flat nails, I think this might work for you though.
I align the stamp to the side of my nails, making a circular movement while placing it on the nail. You want a steady, quick hand with this, or you'll end up with a design looking like mine :-P.
7. Top it off
When your done, it's time to get out the top coat. This can be a little bit tricky because it's very easy to smudge your fresh design. Konad has a top coat especially made for this. You can also use other top coats, just make sure it's not thick and apply it in a floating manner, like you're not really touching the nail with the brush.
Well, this is how I go around doing Konad. It's not something I really fancy doing, it can get very messy!
The nail polishes I used in this how-top are Color Club's Worth the Risque and Revvvoluton. Review coming soon!
No comments:
Post a Comment